86 / GR86 / BRZ Braided Clutch Line

86 / GR86 / BRZ Braided Clutch LineThe GKTECH braided clutch lines are a direct replacement and are stronger than the OEM lines. The OEM lines are rubber which are economical to produce but they're prone to splitting and are susceptible to expanding which in turn gives a spongy feeling, particuarly when heat is introduced. Our braided clutch lines remove this spongy feeling and our optional high temp heat sleeve helps even further. The lines are assembled by us in house in Australia

NOTE: Can NOT be used in conjunction with Nismo engine mounts on an S13/180sx as the mounts raise your motor approximately 20mm's which will make our fan hit your radiator shroud (our fan is 15mm larger in diameter than the OEM SR20 fan) however S14/S15's with Nismo engine mounts are fine and our fan will fit

product benefits and a look into the design process of these products

Pressure adjustments range from 150-1200 PSI and provide for a maximum decrease of 57% in line pressure

- Hub centric to the vehicle to suit 56

The contents:

The OEM diff cover uses just a single bush and stud which is prone to premature wear and excessive movement which can cause the rear stud to break off the cover

com/premium-spherical-swaybar-front-end-links SKU - PRMM-ENDL

com/blogs/news/s-chassis-rear-subframe-comparison

The ergonomic design of the ramps means that moisture is directed away from the tyres and any areas where grip is necessary

This allows the tie rod end balljoint to sit along the same plane as the front lower control arm balljoint

offset rack spacer moving the rack forward to eliminate steering bind on high lock setups

- 100mm PCD with M12 x 1